First Layer Issues - Troubleshooting - V1 Engineering Forum
Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin
P1S - Bad Prints, Troubleshot A Lot Already - Troubleshooting
3D Printing Layer Issues - Advice - V1 Engineering Forum
Well, I'm getting started! - Troubleshooting - V1 Engineering Forum
First Layer Issues - Troubleshooting - V1 Engineering Forum
Troubleshooting 3D prints, first layer issues
First layer issues – Assembly and first prints troubleshooting
Myriad of First Layer Issues {MK3S+} : r/prusa
/wp-content/uploads/2020/04/IMG_9
Annex Engineering K3 - Things You've Made - V1 Engineering Forum
V1 Engineering Inc -V1E.com
First Layer Problems – Assembly and first prints troubleshooting
First Layer Problems – Assembly and first prints troubleshooting
First Layer Issues - Troubleshooting - V1 Engineering Forum
3D print improvements - Troubleshooting - V1 Engineering Forum