PSS Hose Barb Plug - PYI Inc.
Description Documents Description This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 10 knots under power then the PSS Shaft Seal does not require positive water feed. The PSS Shaft Seal can simply be "vented" or you can use this plug in place of the hose barb that's inserted into the carbon stator. "Burping" The PSS Shaft Seal You will also be required to "burp" the PSS Shaft Seal whenever there is air trapped inside. Simply pull back on the carbon stator, separating it from the stainless steel rotor. This will cause a quick mist of water to spray out. Important If your boat will exceed 10 knots under power then it is required that a positive water supply be plumbed to the PSS Shaft Seal for the purpose of lubricating and cooling
PSS Shaft Seal 1 1/2 Shaft & 2 1/4 Shaft Log/Stern Tube, 02-112-214, PYI Inc : Industrial & Scientific
PYI Inc. PSS Type C Shaft Seal
PSS installation instructions (low res).pdf - PYI Inc.
PSS Type A Shaft Seal, PYI Inc
Installing a PSS Shaft Seal - Marine How To
PYI PSS PRO Shaft Seals
1/2 in. Push-On Hose Barb x 1/2 in. Flare 37/45 Female Swivel, 150 PSI Max Pressure Rating 316 Stainless Steel Fitting
This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 12 knots under power then the PSS Shaft Seal does not require positive
PSS Hose Barb Plug
PSS Hose Barb Plug - PYI Inc.
PYI Inc. PSS Type B Shaft Seal
Installing a PSS Shaft Seal - Marine How To
Hose Barb .50 x .375 FPT PP - Cleaning Systems, Inc.