Print failure - became spongy and stringy mid-print – How do I

$ 20.50

4.8
(505)
In stock
Description

I was printing a 73mm high model yesterday. The first 25mm went fine, but then the print became "spongy" and "stringy" as if not enough filament was b

Prints fail halfway through and turn into stringy spongy messes that clog the nozzle. : r/FixMyPrint

Failed 3D Prints, and How to Fix Them : 6 Steps (with Pictures) - Instructables

Extrusion stopped mid-print (Heat creep)

Print failure - became spongy and stringy mid-print – How do I print this? ( Printing help) – Prusa3D Forum

3D Printing First Layer Problems: How to Make It Perfect

3D Printing Troubleshooting: All Problems & Solutions

3D Printing Troubleshooting: All Problems & Solutions

3D Printer Stringing: 5 Simple Solutions

filament - Why is my print getting messed up mid-print? - 3D Printing Stack Exchange