How do I use this hall sensor? 44E 402 - Sensors - Arduino Forum
Hello. I have bought a hall sensor module with 3 pins and I have no data sheet. But what I have found from google is that pin 1 = power, 2 = ground, and 3 = output. I post an image below how I have connected it so far. The problem is that the sensor seems to give no sign of working when a magnet is nearby. By using analogRead and the seriell monitor i can see the sensors value is between 892-893 (depending on resistor). What am I not understanding? Thanks in advance.
Input from multiple sensors to Uno - Hardware - Arduino Forum
What kind of sensor I have to huse? - Sensors - Arduino Forum
Interfacing KY-024 Hall Effect sensor with Arduino
Interfacing KY-024 Hall Effect sensor with Arduino
Can't get hall effect sensors to work (double input, always on) - General Electronics - Arduino Forum
Getting the position from two between hall sensors? - Project Guidance - Arduino Forum
KY-024 Hall effect sensor giving bad readings - Sensors - Arduino Forum
Hall sensor - do I get something wrong? - Science and Measurement - Arduino Forum
Explore - EasyEDA
Arduino 101: Using a Hall effect sensor — Steemit